connorcruise123
Geregistreerd op: 17 Mei 2018 Berichten: 5
|
Geplaatst: 25-05-2018 10:04:54 Onderwerp: Circuit Sword Major Wifi Issues |
|
|
Hello,
I just finished my CSO and for the most part, everything seems to be working but I cannot actually use it because onboard wifi is extremely finicky and inconsistent. I put three layers of Kapton tape on the whole wifi module, cut down the four solder points of the USB port, and put a piece of tape on each pair of said solder points
In the last two days, I have only been able to get wifi to connect once. Most of the time I get an X over the wifi icon. I am not sure what that even means. I have also tried using an Edimax (EW-7611ULB) USB wifi dongle, but the Circuit Sword build doesn't detect it. Ironically, if this requires driver/kernel updates to support the dongle, I am stuck since I have no wifi access. I can't fully test the build (ie sound) because I can't load any roms on it. I also tried not tightening that corner case screw as much as to not put pressure on the wifi chip but it hasn't made a difference. The only time wifi worked, it lasted about 5 minutes then went to the X icon.
Tester mode shows OK for every component and no issues with the display.
Please help
I didn't find the right solution from the internet.
References:
https://sudomod.com/forum/viewtopic.php?t=5642
Business video marketing company
Thank you |
|